A collection of tips on how to be successful at plumbing makes the perfect starting point for a beginner. Below is just such a collection that will hopefully assist the eager novice into eventually becoming a pro when it comes to plumbing.
Check the filters in your furnace, regularly. If these filters have not been cleaned or replaced recently, they may become clogged. This will affect how well your furnace is able to work, meaning that you may not have enough heat during the winter. Take this simple step, as soon as the weather starts to become cold.
On very cold winter nights, allow your faucets to trickle slightly, especially if your pipes are located in a crawlspace. The running water prevents the pipes from freezing as quickly as they would otherwise. You can catch the water and use it for other household needs to prevent wasting it.
To avoid having your outdoor faucets freeze up in the winter, detach all hoses before the first freeze. Also, close the shutoff valve that leads to the outdoor faucets, then turn on the outdoor faucets to let any remaining water in the lines drain. Once temperatures warm up in the spring, you can reverse the process.
Got a leaky pipe? In many cases you can repair this yourself without the expense of a plumber. If a joint is leaking, tighten it with a pipe wrench. If the leak is coming from a damaged section of pipe, you can try repairing with a store-bought patching kit. One method involves applying waterproof tape to the section of pipe where there is leakage. Before applying the tape, make sure the pipe is thoroughly dry. Make sure that the tape covers two to three inches on either side of the breakage in the pipe.
It is not always necessary to call in a plumber when you have a damaged section of pipe in your plumbing. There are repair kits you can buy in your local hardware store which are excellent in repairing leaks. If you have a small leak, you can rub a compound stick over the hole or crack in the pipe to seal it shut. Epoxy paste is also an excellent remedy for a leaking pipes. Make sure you turn off the water and completely dry the pipe before applying the epoxy.
It is very important to to use lots of cold water when running your garbage disposal. The blades will stay sharper, and the overall disposal process will run smoother. Grease will stay solid and go through your drain with cold water; you don’t want gooey grease in your pipes.
Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.
Well, hopefully the aforementioned collection of tips were enough to give you a great start on what to do and expect when it comes to maintaining your own plumbing. This collection was carefully constructed to be an aid in your arsenal so that you can begin to hone your plumbing skills into having a great plumbing system.